Vipavc, Daniel

Dr. Daniel Vipavc

Es wurden leider keine Projekte gefunden.

Plettke R., Vipavc D., Grüner M., Hagenah H., Merklein M.:
The influence of the annealing process in the fabrication of helical needles for the suture in deep wound cavities
In: International Journal of Computer Integrated Manufacturing 27 (2014), S. 960-967
ISSN: 0951-192X
DOI: 10.1080/0951192X.2013.820350

Merklein M., Plettke R., Schneider T., Opel S., Vipavc D.:
Manufacturing of sheet metal components with variants using process adapted semi-finished products
In: Key Engineering Materials 504-506 (2012), S. 1023-1028
ISSN: 1013-9826
DOI: 10.4028/www.scientific.net/KEM.504-506.1023
Plettke R., Vatter P., Vipavc D.:
Basics of process design for 3d freeform-bending
In: Steel Research International SPL. ISSUE (2012), S. 307-310
ISSN: 1611-3683
Plettke R., Vipavc D., Grüner M., Hagenah H., Merklein M.:
Prototype Manufacturing of Helical Needles for Suture in Deep Wound Cavities
1st Int.Conf. Design and Processes for medical devices PROMED (Rivolti (TO))
In: E. Ceretti, A. Fiorentino, L. Giorleo, C. Giardini (Hrsg.): Proc. 1st Int.Conf. Design and Processes for medical devices PROMED 2012

Plettke R., Vipavc D., Vatter P.:
Influence factors of three-roll-push-bending
1st Int. Tube and Profile Bending Conf.
In: Tekkaya, A. E. (Hrsg.): Proc. 1st Int. Tube and Profile Bending Conf. 2011

Hagenah H., Vipavc D., Plettke R., Merklein M.:
Numerical Model of Tube Freeform Bending by Three-Roll-Push-Bending
2nd International Conference on Engineering Optimization (Lissabon)
In: Associacao Portuguesa de Mecanica Teória, Aplicada e Computacional (Hrsg.): 2nd International Conference on Engineering Optimization 2010
Hagenah H., Vipavc D., Vatter P., Cojutti M., Plettke R.:
Creation of the Data Base for the Process Design of the Three-Roll-Push Bending Process
In: Teti, R. (Hrsg.): 7th CIRP Int. Conf. Intelligent Computation in Manufacturing Engineering 2010
Plettke R., Vatter P., Vipavc D., Cojutti M., Hagenah H.:
Investigation on the Process Parameters and Process Window of "Three-Roll-Push-Bending"
In: Hinduja, S.; Li, L. (Hrsg.): Proc. 36th Matador Conf. 2010

Cojutti M., Vipavc D., Hagenah H., Merklein M.:
An innovative approach for the process design for three-roll bending of plain tubular components
In: Angeles Gutierrez, M.; Sedlmaier, A.; Galdós, L. (Hrsg.): Proc. 1st Int. Congress on Roll Forming 2009